Beautifully made, rigid and heavy, numerous examples of this 60-inch tall milling machine (with its handy 17.75" x 5" table) are still to be found in amateur workshops throughout the British Isles. First manufactured by George Taylor & Son of Coventry, England, before the First World War, the machine went through several changes until its demise as a Mk. 2 version in what must have been the early 1950s. The main body of the miller was fitted to an semi-integral (cast-iron) stand that allowed drive pulleys to be mounted in correct alignment and a small chip tray to be provided. The column was open on the right-hand side and fitted with a deep, cast-iron door level with the mounting of the knee, to provide collet and tool storage; this was a convenient arrangement but one that unfortunately weakened the structure in just the place where it should have been as rigid as possible.
While very early versions of the Mk. 1 had plain bearings fitted to both the main spindle and the various jockey pulleys and countershaft later models had ball races throughout leading to much easier running and far less power loss. It is almost certain that the miller would have been offered with a variety of spindle nose fittings and examples have been found with a No. 2 Morse, Brown & Sharpe and Jarno tapers - and also, incredibly, a plain bore. Almost certainly in line with the change to anti-friction bearings the spindle was further modified with a 26?taper to accept direct-mounting "double-split" collets of a type not dissimilar to the modern "ER" type. When the Mk. 2 was introduced at some point in the 1930s a change was made to a lower bronze bearing and an upper ball race.
Of a very old-fashioned, traditional design, the drive system of early Mk. 1 machines was supplied for connection to overhead factory line-shafting with no provision made for a built-on motor. However, with the increased popularity of self-contained drives Taylor modified the miller to accept a side-mounted, two-speed 3 phase motor; the rest of the drive remained unchanged, with the belt from the motor passing to a 3-step pulley (at the back of the main column) on the inside of which was a single pulley that transmitted the drive upwards and round two adjustable jockey pulleys before wrapping round the (unguarded) spindle pulley. Later machines were much altered with, amongst other changes, an updated and fully-enclosed drive system that provided full protection for the operator from the belt runs.
With three generously-proportioned T-slots, the table was fitted with either a 2 or 3-speed feed, driven by flat belts with the power taken from a small 2-step pulley concentric with the main input/output pulley on the back of the main column. A telescopic cardan shaft, with a single universal joint outboard of the drive pulley, transmitted the power to the table; the necessary angular movement at the table end was arranged by allowing the worm assembly to rotate around the slotted table feed screw. A pre-set, automatic knock-off arrangement was fitted and consisted of an external housing that held a tappet-like pin with a bevelled end pushed down by wedge-shaped striker plate that slid in a T slot along the table's front face. The tappet pin, which had a rack cut into its lower end to activate the release mechanism, could also be operated by a hand lever. Longitudinal travel was 9.5", across 3.5" and vertically 8.25".
A micrometer dial was fitted only to the right-hand end of the table feed screw, although a handle was provided at the other with the screw passing through a simple support bracket that hung down from the underside of the table. The design of supporting bracket for the table-feed shaft was very distinctive and can be used as a useful recognition aid if a machine has lost its cast bronze badge to a "collector"; unfortunately the bracket was retained by two set screws, with very shallow slots across their elegantly turned faces; even using the special wide screwdrivers then common it would only have been possible to apply enough torque to make them adequately rather than securely tight.
In its original form the miller occupied a floor space of 34" x 27" and weighed about 0.25 tons.