<code id="sa0bz"></code>
    <th id="sa0bz"></th>

  1. <strike id="sa0bz"></strike>
      <strike id="sa0bz"></strike><del id="sa0bz"><small id="sa0bz"></small></del>
      <th id="sa0bz"><video id="sa0bz"></video></th>

      E-Mail Tony@lathes.co.uk 
      Home    Machine Tool Archive    Machine Tools For Sale & Wanted
      Machine Tool Manuals   Machine Tool Catalogues   
      Belts   Accessories   Books


      Drill & Milling Machine
      Quill-return Springs
      Both springs below - UK-made - are available from stock

      Size 001 = 0.5 inches (13 mm) deep by 1.5 inches (37 mm) in diameter over the coils. For lighter-duty machines with up to 0.5 inch drilling capacity and as originally as fitted to the Fobco "Star" Drills
      If the spring would fit into the housing on your drill but is not wide enough, consider using two set side-by-side. If too wide the spring can be reduced in width (with care taken not to over-heat it) by using a horizontal band sander.
      The size 001 spring can be ordered online here

      Size 002 = 0.75 inches deep (19 mm) by 2.45 inches (62 mm) in diameter over the coils A much heavier spring for drills and millers with a 1-inch drilling capacity and originally intended for use on the Fobco 7/8 and 10/8 drills. If the spring would fit into the housing on your drill but is not wide enough, consider using two set side-by-side. If too wide the spring can be reduced in width (with care taken not to over-heat it) by using a band sander.
      The Size 002 spring can be ordered online here

      ǮֻϷ