<code id="sa0bz"></code>
    <th id="sa0bz"></th>

  1. <strike id="sa0bz"></strike>
      <strike id="sa0bz"></strike><del id="sa0bz"><small id="sa0bz"></small></del>
      <th id="sa0bz"><video id="sa0bz"></video></th>

      email: tony@lathes.co.uk
      Home   Machine Tool Archive   Machine-tools Sale & Wanted
      Machine Tool Manuals   Catalogues   Belts   Books  Accessories

      Fleck Lathes
      Fleck U. Co. Charlottenburg


      Fleck U. Co were based in Charlottenburg, an area of Berlin, and known for their small high-precision, standard engine-type as well as a number of production capstan machines of various sizes.
      A strange cross between a precision plain-turning bench lathe and a general workshop machine, the 3" x 12" (90 x 300 mm) first Fleck lathe shown below is very rare in the UK - and would have been constructed circa 1920 to 1935. Of high quality design and execution, with precise detailing, it is was unusual in having screwcutting -  but unfortunately not a slow-speed backgear mechanism and the provision of power cross feed (from a shaft geared to the leadscrew and fitted with a dog clutch) - a sophistication rarely found on this class of machine.
      With a wide bed - cast integrally with the headstock - carrying pairs of separate V and flat ways for carriage and tailstock the lathe had a saddle with conventional wings at the front but a very much shorter section at the rear. The compound slide had a decently wide cross slide (with sufficient length to guard the feed screw both at the front and rear) yet with a traditional (though very useful) long-travel top slide with exposed ways of a type that might have been expected on a simpler machine.
      With relatively slender, flat-topped posts supporting the plain bearings the headstock had the appearance of a machine built one or more decade earlier, though the very fine-pitch changewheels were quite at odds with early practice.
      Flecks range of engineering shop lathes varied in specification, the limited amount known about them indicating that while some had full screwcutting gearboxes, backgear and power cross feed, others were constructed as production lathes, these needing only basic equipment and a paucity of advanced features. A typical example of a backgeared and screwcutting general purpose Fleck lathe is shown towards the bottom of this page.
      If any reader has a Fleck lathe the writer would be very interested to hear from you..

      High-resolution pictures - may take time to open

      A slightly different Fleck lathe with an embryonic gap in the bed that allowed a job some 200 mm in diameter to be turned on a faceplate

      A well-specified Fleck lathe from the 1934 with backgear,  screwcutting gearbox and power cross feed. This model was available with an 82 mm centre height and either 230 or 325 mm between centres or as a100 mm centre height model with 500 mm between centres.

      Made in 1928 this 82 mm x 230 mm Flack was a very much simpler and cheaper example with no backgear, a perfunctory apron and a carriage handwheel that was geared directly to the bed rack with no step-down gearing.

      email: tony@lathes.co.uk
      Home   Machine Tool Archive   Machine-tools Sale & Wanted
      Machine Tool Manuals   Catalogues   Belts   Books  Accessories

      Fleck Lathe
      Fleck U. Co. Charlottenburg
      ǮֻϷ